“TTL To RS485 Module Serial Port MCU Automatic Flow Control Module” has been added to your basket. View basket
Showing 901–920 of 985 results
Tube Type Inductive Proximity Sensor Detection Switch NPN DC6-36V 4mm
Rated 0 out of 5
0 Reviews- Output Type: NPN-NO
- Red LED checks the state of the proximity sensor
- High repeated positioning accuracy
- High switching frequency
- Wide voltage range
- Antivibration, dust, water and oil prevention
- Reverse power protection, short circuit protection, directly connecting with PLC
- Can replace small switches and limit switches
Turbidity Sensor With Amplifier Module Kit
Rated 0 out of 5
0 Reviews- Working voltage: 5.00V DC
- Analogue output: 0~4.5V;
- Digital output: high/low-level signal
- Module size: 38.6mm*22.1mm
U-blox NEO-6M GPS Module with EPROM
Rated 0 out of 5
0 Reviews- 5Hz position update rate
- EEPROM to save configuration settings
- Rechargeable battery for Backup
- The cold start time of 38 s and Hot start time of 1 s
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600)
- SuperSense ® Indoor GPS: -162 dBm tracking sensitivity
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN)
- Separated 18X18mm GPS antenna
Ultra Torque Quarter Scale 60kgcm Metal Gear Servo Motor
Rated 0 out of 5
0 Reviews- Operating voltage: 6 V to 8.4 V
- Durable Metal Gear
- Dual Ball Bearing
- Less Noise
- Gear Type: All Metal Gears
- Stable and shock proof double ball bearing design
- Operating Angle: 180 degree
Ultrasonic Sensor Module Water Proof JSN-SR04T For Arduino
Rated 0 out of 5
0 Reviews
This Ultrasonic Sensor Module Water Proof JSN-SR04T meets this requirement. It has a good performance and almost the same usage of HC-S04 module. Compares to the SR04 module, this module is more easy to install with waterproofing.
Ultraviolet UV Detection Sensor Based On GUVA-S12SD 240NM-370NM
Rated 0 out of 5
0 Reviews
Can be used in Uv tester, uv watches, outdoor sports equipment, mobile phone, etc
Universal PCB Holder Stand For Soldering SS
Rated 0 out of 5
0 Reviews
Ideal tool for clamping Mobile Phone PCB, for soldering / Desoldering or rework.PCB fixture with 8 different grooves. Facilitate the Mobile phone CPU repair and soldering with tweezers.
USB Break Out Board Type A,B & Micro
Rated 0 out of 5
0 Reviews
This is very useful multi USB break out board for pin out type A,type B & micro usb port.
USB DC-DC Converter
Rated 0 out of 5
0 Reviews
This module uses imported high-performance chip, the performance is superior to the general module. 2. Enter any 0.9V ~ 5V DC voltage of 5V DC output voltage can be stable, with a single AA battery can deliver up to 200 ~ 300MA current, two AA batteries to output 500 ~ 600MA of current.
USB Mini Discharge Load Resistor 2A/1A
Rated 0 out of 5
0 Reviews- Switch and USB interface design.
- Rated Power: 5W-10W.
- Type: Fixed Resistor.
- Size: 75 x 15 x 11.6 (LxWxH)mm.
