Showing 901–920 of 985 results
Tube Type Inductive Proximity Sensor Detection Switch NPN DC6-36V 4mm
Rated 0 out of 5
0 Reviews- Output Type: NPN-NO
- Red LED checks the state of the proximity sensor
- High repeated positioning accuracy
- High switching frequency
- Wide voltage range
- Antivibration, dust, water and oil prevention
- Reverse power protection, short circuit protection, directly connecting with PLC
- Can replace small switches and limit switches
Turbidity Sensor With Amplifier Module Kit
Rated 0 out of 5
0 Reviews- Working voltage: 5.00V DC
- Analogue output: 0~4.5V;
- Digital output: high/low-level signal
- Module size: 38.6mm*22.1mm
U-blox NEO-6M GPS Module with EPROM
Rated 0 out of 5
0 Reviews- 5Hz position update rate
- EEPROM to save configuration settings
- Rechargeable battery for Backup
- The cold start time of 38 s and Hot start time of 1 s
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600)
- SuperSense ® Indoor GPS: -162 dBm tracking sensitivity
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN)
- Separated 18X18mm GPS antenna
Ultra Torque Quarter Scale 60kgcm Metal Gear Servo Motor-FT6560M
Rated 0 out of 5
0 Reviews- Operating voltage: 6 V to 8.4 V
- Durable Metal Gear
- Dual Ball Bearing
- Less Noise
- Gear Type: All Metal Gears
- Stable and shock proof double ball bearing design
- Operating Angle: 180 degree
Ultrasonic Sensor Module Water Proof JSN-SR04T For Arduino
Rated 0 out of 5
0 Reviews
This Ultrasonic Sensor Module Water Proof JSN-SR04T meets this requirement. It has a good performance and almost the same usage of HC-
Ultraviolet UV Detection Sensor Based On GUVA-S12SD 240NM-370NM
Rated 0 out of 5
0 Reviews
Can be used in Uv tester, uv watches, outdoor sports equipment, mobile phone, etc
Universal PCB Holder Stand For Soldering SS
Rated 0 out of 5
0 Reviews
Ideal tool for clamping Mobile Phone PCB, for soldering / Desoldering or rework.PCB fixture with 8 different grooves. Facilitate the Mobile phone CPU repair and soldering with tweezers.
USB Break Out Board Type A,B & Micro
Rated 0 out of 5
0 Reviews
This is very useful multi USB break out board for pin out type A,type B & micro usb port.
USB DC-DC Converter
Rated 0 out of 5
0 Reviews
This module uses imported high-performance chip, the performance is superior to the general module. 2. Enter any 0.9V ~ 5V DC voltage of 5V DC output voltage can be stable, with a single AA battery can deliver up to 200 ~ 300MA current, two AA batteries to output 500 ~ 600MA of current.
USB Mini Discharge Load Resistor 2A/1A
Rated 0 out of 5
0 Reviews- Switch and USB interface design.
- Rated Power: 5W-10W.
- Type: Fixed Resistor.
- Size: 75 x 15 x 11.6 (LxWxH)mm.
