Arduino Nano R3 Board

The Arduino Nano R3 Board with CH340 chip without USB Cable chipboard is based on the famous Arduino platform and does all the functions of Uno, but with a smaller footprint.

The Arduino Nano R3 Board chip without USB Cable is vital for your small project where you don’t need much of a pin-outs but the small size is very important to make it look good.

Micro controller is atmega328, operating voltage (logic level)5 v;input voltage (recommended)7-12 v;input voltage) limits) 6-20v;digital i/o pins 14 (of which 6 provide pwm output);analog input pins 8;dc current per i/o pin 40 ma;flash memory 32 kb (atmega328) of which 2 kb used by boot loader;ram 2 KB (atmega328);eeprom 1 kb (atmega328);clock speed 16 mhz.

• Operating Voltage (logic level) 5 V
• Input Voltage (recommended) 7V-12V
• Digital I/O Pins 14 (of which 6 provide PWM output)
• Flash Memory 32 KB (ATmega328) of which 2 KB used by bootloader
• Microcontroller ATmega328P

Features

• Automatic reset during program download
• Power OK blue LED
• Green (TX), red (RX) and orange (L) LED
• Auto sensing/switching power input
• Small mini-B USB for programming and serial monitor
• ICSP header for direct program download
• Standard 0.1″ spacing DIP (breadboard friendly)
• Manual reset switch

Specifications

• Microcontroller : Atmel ATmega328
• Operating Voltage (logic level): 5V
• Input Voltage (recommended): 7-12 V
• Input Voltage (limits): 6-20 V
• Digital I/O Pins: 14 (of which 6 provide PWM output)
• Analog Input Pins: 8
• DC Current per I/O Pin: 40 mA
• Flash Memory: 32 KB of which 2 KB used by bootloader
• SRAM: 2 KB
• EEPROM: 1 KB
• Clock Speed: 16 MHz

• 1 X Arduino Nano R3 Board