Sensors Module
Showing 1–20 of 165 results
801S Vibration Shock Sensor Module
Rated 0 out of 5
0 Reviews- When the output valid signal is high, the light goes out
- The sensitivity is adjustable (fine-tuning)
- The wide detection range of vibration, no direction
- With mounting holes, firmware installation is flexible and convenient.
A3144 Hall Effect Sensor Module
Rated 0 out of 5
0 Reviews- Digital Output Hall-effect sensor.
- Operating voltage: typically 5V.
- Output Current: 25mA.
- It can be used to detect both the poles of a magnet
AC Voltage Sensor ZMPT10 For Arduino
Rated 0 out of 5
0 Reviews
This module is based on a high precision ZMPT101B voltage Transformer. This module makes it easy to monitor AC mains voltage upto 250 volts. This module comes with Multi-turn trim pot which can be used for adjusting the Analog output.Using ZMPT101B AC Voltage Sensor you can easily measure main voltage using Arduino or even Raspberry Pi (external ADC required)
Acrylic Case For XH-W1209 Temperature Control Module
Rated 0 out of 5
0 Reviews- Good Quality Material
- Crystal Clear
ACS712 20A Current Sensor
Rated 0 out of 5
0 Reviews
The 20A Range Current Sensor Module ACS712 consists of a precise, low-offset, linear Hall circuit with a copper conduction path located near the surface of the die. Applied current flowing through this copper conduction path generates a magnetic field in which the Hall IC converts into a proportional voltage.
ADS1115 16-Bit ADC - 4 CH With Programmable Gain Amplifier
Rated 0 out of 5
0 Reviews- Wide supply range: 2.0V to 5.5V
- Programmable data rate: 8SPS to 860SPS
- LowCurrent Consumption: Continuous Mode: Only 150µA Single-Shot Mode: Auto Shut-Down
- It has Internal low-drift voltage reference
- Internal Oscillator.
- Internal PGA.
ADXL335 3-Axis Accelerometer
Rated 0 out of 5
0 Reviews
It can measure the static acceleration of gravity in tilt-sensing applications, as well as dynamic acceleration resulting from motion, shock, or vibration. This breakout board comes with an onboard voltage regulator and works at both 3.3V & 5V (3-5V).
ADXL345 IIC / SPI Digital Tilt Sensor Accelerometer
Rated 0 out of 5
0 Reviews
The ADXL345 IIC / SPI Digital Tilt Sensor Accelerometer is a small, thin, low power, 3-axis MEMS accelerometer with high resolution (13-bit) measurement at up to +-16 g. Digital output data is formatted as 16-bit too complement and is accessible through either a SPI (3- or 4-wire) or I2C digital interface.