Showing 61–80 of 100 results
NEMA23 30.61Kg-cm Hybrid Stepper Motor D-Type Shaft
Rated 0 out of 5
0 Reviews
Ideal Motor for CNC machines. Standard Nema23 frame size. 18.9Kgcm bipolar mode torque.
- Step Angle Step Angle: 1.8 °
- Current: 4 A/Phase
- Motor Typr: Bipolar
- Holding Torque: 306 N-cm
- Detent torque: 6.8 N.cm (Maximum)
- Lead Wires: 4
- Shaft diameter: 8 mm
NEMA23 7.2kg-cm Dual Shaft Hybrid Stepper Motor
Rated 0 out of 5
0 Reviews
Step Angle Step Angle: 1.8 °, Current: 1 A/Phase, Holding Torque: 72 N-cm, Detente torque: 3.6 N.cm (Maximum), Lead Wires: 6, Shaft diameter: 6.35 mm (both sides)
Nema23 Stepper Motor Right Angle Mounting Bracket/Clamp
Rated 0 out of 5
0 Reviews- Most accurate design for NEMA23 Stepper Motor
- Mounting Holes Size: 5mm
- Equips extra holes for user-defined motor fitting.
NEMA34 46kg-cm Hybrid Stepper Motor
Rated 0 out of 5
0 Reviews- Step Angle Step Angle: 1.8 °
- Current: 4 A/Phase
- Lead Wires: 4
- Shaft diameter: 14 mm
- Shaft Length : 32mm
Servo Driver-I2C-PCA9685 for Arduino-Raspberry Pi-16CH.-12Bit
Rated 0 out of 5
0 Reviews
This 16-CH. 12-bit PWM/Servo Driver-I2C-PCA9685 for Arduino-Raspberry Pi uses I2C 7-bit address between 0x60-0x80, selectable with jumpers.Terminal block for power input (or you can use the 0.1" breakouts on the side).Reverse polarity protection on the terminal block input.3 pin connectors in groups of 4 so you can plug in 16 servos at once (Servo plugs are slightly wider than 0.1" so you can only stack 4 next to each other on 0.1" header
Servo Mount Holder Bracket For SG90/MG90 - 2Pcs
Rated 0 out of 5
0 Reviews
Servo Bracket holder for the SG90 Micro 9g Servo. It comes complete with the screws. Perfect fitting for Micro servo 9g/SG90.Acrylic 9G Servo Bracket.
